Návrh 3D tiskárny typu delta pi s temperovanou podložkou s využitím systémů CAE
Loading...
Date
Authors
Koudela, Ondřej
ORCID
Advisor
Referee
Mark
A
Journal Title
Journal ISSN
Volume Title
Publisher
Vysoké učení technické v Brně. Fakulta elektrotechniky a komunikačních technologií
Abstract
Předložená diplomová práce se věnuje tématice 3D tisku s využitím nekomerčních 3D tiskáren typu RepRap. V této práci je stručně popsán vývoj trendů nekomerčních RepRap tiskáren, teorie FDM tisku s rozborem a s porovnáním materiálů používaných při tisku, problematika metody konečných objemů a teorie šíření tepla. V praktické částí jsou na základě simulací z programu SolidWorks Flow Simulation diskutovány dva základní způsoby vyhřívání temperované podložky, dále teplotní profil trysky a tepelné proudění v celé sestavě tiskárny. Výstupem této práce je návrh optimalizovaného modelu a fyzická sestava 3D tiskárny typu delta pi.
This master's thesis deals with 3D printing using non-commercial 3D RepRap type printers. This work briefly describes development trends of non-commercial RepRap printers, theory of FDM print with analysis and comparison of materials, which are used in printing and the issue of the finite volume method and theory of heat diffusion. The practical part based on simulations from SolidWorks Flow Simulation discussed two basic methods of heating hot bed, then the temperature profile of hot end and the heat flow in full assembly of the printer. Outcome of this work is design an optimized model and the physical assembly of 3D printer delta pi type.
This master's thesis deals with 3D printing using non-commercial 3D RepRap type printers. This work briefly describes development trends of non-commercial RepRap printers, theory of FDM print with analysis and comparison of materials, which are used in printing and the issue of the finite volume method and theory of heat diffusion. The practical part based on simulations from SolidWorks Flow Simulation discussed two basic methods of heating hot bed, then the temperature profile of hot end and the heat flow in full assembly of the printer. Outcome of this work is design an optimized model and the physical assembly of 3D printer delta pi type.
Description
Citation
KOUDELA, O. Návrh 3D tiskárny typu delta pi s temperovanou podložkou s využitím systémů CAE [online]. Brno: Vysoké učení technické v Brně. Fakulta elektrotechniky a komunikačních technologií. 2015.
Document type
Document version
Date of access to the full text
Language of document
cs
Study field
Elektrotechnická výroba a management
Comittee
prof. Ing. Karel Bartušek, DrSc. (předseda)
doc. Ing. Jiří Vaněk, Ph.D. (místopředseda)
Ing. Jiří Luňáček, Ph.D., MBA (člen)
Ing. Bohuslav Res, CSc. (člen)
Ing. Jiří Ovsík (člen)
Date of acceptance
2015-06-08
Defence
Proč jste zvolili kruhovou podložku?
Jaká byla teplota při otevřeném tisku?
Student seznámil zkušební komisi s cíli a řešením závěrečné vysokoškolské práce a zodpověděl otázky a připomínky oponenta.
Result of defence
práce byla úspěšně obhájena
Document licence
Standardní licenční smlouva - přístup k plnému textu bez omezení